Crown 6" - 14

This cyma 6" - 14 crown mould measures 6.000" wide by .812" thickness, allowing the detail to be machined sprung (laying horizontally flat) out of four-quarter lumber. The decorative profile is composed of a 3/16" tall vertical line and a 31/64" cove in the upper portion, connected to a free-flowing two tangent radius cyma recta and a 25/64" tall by 9/32" broad squared line in the center, attached to a two tangent radius ogee with a 23/64" broad line segment on the bottom of the pattern. The spring angles are fixed at forty-five degrees, these dedicated back bevels set the installed height at 4-3/32" tall with a projection of 4-3/8" wide. We have a similar style design in the same width. Still, with alternative inner dimensions for your review and consideration, crown 6.000" - 5.

Review our commentary about axial constant positioning for crown bevels, the article will help you dial this profile in axially provided the machine is adequately calibrated. Tour high points in the detail were deliberately positioned on the same plane; our disciplined design features will assure excellent hold-down conditions while milling, as long as the machine's pressure shoe is parallel to the machine bed plates. Perhaps a felt-lined pressure shoe will help eliminate any unsightly burnish mark caused by the metal hold down.