Panel Moulding 1-1/8" - 9

This decorative panel molding 1-1/8" - 9 measures 1.125" width by .687" thickness, requiring the use of a 1-3/8" wide blank of four-quarter lumber for machining on an industrial-grade molder. The graceful profile contains a 3/32" wide flat line segment above the 1/4" wide rabbet for the panel, on the top left. The line connects to a gentle downsloping three tangent radius s-shaped curvature. The graceful convex arc transitions into a small classy half-circle with an additional 3/32" broad fillet on the design's right side. We offer an additional pattern in a slightly smaller width and thickness for your review and consideration, panel moulding 1.093".

Ever notice why some moldings look better than other trim patterns in homes, offices, and older buildings. You may want to review our article on knife marks per inch. Read about how machine feed rates and rpm of cutter heads can directly determine the quality of the products you produce. Following or exceeding industry standards will allow your company to lead the way in molding artisanship.

For molding knife quoting purposes, click to open the calculator below; we supplied only the important measurements, enter the appropriate dimension in the boxes provided. A brief detailed explanation on how to use the calculator is located here. If you would like some assistance with the dimensions, print a copy of our fraction - decimal - millimeter chart, place it on the molder or around the shop to help machine operators save time and increase accuracy during setup procedures.

Width = 1.125" / Depth of Cut = .421" (top knives).

Thickness = .687" / Depth of Cut = .250" (left cutters).