WM 60 Crown 1-3/4" - 7

This WM 60 crown mould 1-3/4" - 7 measures 1.750" in width by .563" in thickness. The small terminating profile comprises two tangent radiuses in the center connected to a 1/2" tall line on the top left corner. The lower section retains 23/64" vertical by 13/32" horizontal lines on the design's bottom right edge. The fixed spring angles are at thirty-eight and fifty-two degrees; these specific back bevel cuts set the installed height at 1-3/8" tall with a projection of 1-3/32" across the top. The recommended rough wood rip size for milling sprung (laying horizontally flat) using four-quarter lumber is 2" wide.

Two high points in the design were deliberately positioned on the same plane. This custom design feature ensures excellent hold-down conditions while milling. Read our commentary about axial constant positioning for crown bevels. The article will help you dial this profile in axially on the first piece of lumber, provided the machine is axially calibrated.

The current combined high-speed knife steel & template prices are listed below for quoting purposes. You may only need knives for a specific cutter head on the itemized costs, saving money using knives you already own. On most of our crown designs, we utilize a full 2.375"/60mm cutter head for the back bevel angles to allow for multiple axial adjustments on a wide range of profiles.