Drawer Front Moulding 1-3/4" - 3

This intriguing drawer front molding 1-3/4" - 2 measures 1.750" width by .781" thickness, allowing the use of four quarter lumber for machining on a commercial molder. The custom pattern retains a recessed 1/4" wide half-circle joined to a 3/8" wide by 1/8" deep dado on the top left. The plow connects to a 23/32" flat line with a 1/8" rolled inner edge merged with a 5/64" sunk fillet and an additional 1/4" half bead with a 19/32" convex arc, positioned above the dado for the panel on the right side of the design. We offer a matching door rail of this pattern for your review and consideration, door rail 2.500"- 51.

Ever notice why some moldings look better than other trim patterns in homes, offices, and older buildings. You may want to review our article on knife marks per inch. Read about how machine feed rates and rpm of cutter heads can directly determine the quality of the products you produce. Following or exceeding industry standards will allow your company to lead the way in molding artisanship.

For molding knife quoting purposes, click to open the calculator below; we supplied only the important measurements to enter the appropriate sizes in the boxes provided. A brief detailed explanation on how to use the calculator is located here. If you would like some assistance with the dimensions, print a copy of our fraction - decimal - millimeter chart, place it on the molder or around the shop to help machine operators save time and increase accuracy during setup procedures.

Width = 1.750" / Depth of Cut = .375" (top cutters).