Crown 4" - 2

This beveled 4" - 2 terminating crown mould comprises 29/64" tall by 15/32" broad perpendicular lines on the top left, attached to a 2-11/16" wide splay faced forty-five-degree beveled section in the center, connected to a 15/32" tall by 29/64" broad squared lines at the bottom right side of the design. The spring angles are at forty-five degrees; the dedicated back bevels keep the face sides of the pattern parallel to the wall and ceiling. These specific back angle positions lock the installed height at 2-53/64" tall with a 2-53/64" projection across the top. The pattern measures 4.000" in width by .750" in thickness. The recommended rough wood rip-size milling sprung (laying horizontally flat) using four-quarter lumber is 4-1/4" wide.

The present-day combined high-speed steel knives & profile template prices are listed below for quoting purposes. On most of our cove, crown, and bed mould designs, we utilize a full 2.375"/60mm cutter head for the back cut angles to allow for multiple axial adjustments on a wide range of patterns.