Crown 2-13/16" - 7

This conventional 2-13/16" - 7 crown mould measures 2.828" width by .687" thickness, allowing the use of four-quarter lumber for milling sprung (laying horizontally flat) on an industrial-grade molder. The traditional terminating profile contains a 3/8" tall vertical line segment on the top left. The line joins a two-tangent radius s-shaped curvature forming the cyma recta in the center, attached to a 7/32" vertical fillet merged with a 23/64" cove and a 3/8" broad line segment on the design's bottom right side. The set spring angles are at forty-five degrees; these dedicated back bevels keep the face side of the profile parallel to the wall and ceiling when installed; they also lock in the positioned height at two-inches tall with a projection of two-inches across the top.